beginner Certificate on completion

Arduino Robotics Bootcamp

Build, wire and tune a line-following robot in a single day.

A full-day hands-on session. By the end you will have built and tuned a line-following robot, and understood every part of it: motor driving, sensor calibration, and a PID loop you adjusted yourself.

Hardware is provided for the day. Bring a laptop with the Arduino IDE installed — the confirmation email includes setup instructions.

What you will cover

Motor driving and PWM speed control
Reading and calibrating reflectance sensors
Writing a control loop from scratch
Tuning PID without guesswork
Debugging when the robot misbehaves

Before you come

None. Some programming experience helps but is not required.

Cancellations

Free cancellation up to 48 hours before the session starts. After that the seat is non-refundable but transferable.